32/EN
Adjusting the amount of rinse aid
1. After turning on the machine, press Time
Delay and P+/P keys simultaneously.
After the countdown (3, 2, 1) is displayed
keep the keys pressed for a while.
2. Press P+/P to move to position (P) on
the display.
3. Set to the appropriate level with the Time
Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
End of programme
When the programme you have
selected comes to an end, an audible
warning signal will warn you to turn off
your machine. This audible signal will
warn you with certain intervals before it
turns off.
End of Programme indicator will light up
when the washing programme is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the socket.
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your dishes
will dry in a shorter time if you leave the
door of your machine ajar during this
period. This process will increase the
drying effectiveness of your machine.
Water cut-off warning
If mains water is cut or water inlet tap is
turned off the machine cannot take water in
and E:02 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the water
inlet is checked regularly by the machine;
when the water is restored E:02 icon will
disappear after a while and the washing
programme resumes.
Overflowing warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety
is assured, E:01 icon will disappear. If E:01
does not disappear, there is a permanent
fault. In this case the authorised service
should be contacted.
InnerClean
(depends on model)
This programme is recommended to be
operated on each 1-2 months for machine
cleaning and necessary hygiene. The
programme should be operated while the
machine is empty.
In order to achieve an efficient result, it is
recommended to use together with special
machine cleaning agents.
Do not use this programme to
clean dishes. As it operates in high
temperatures, it is harmful for the
dishes.