Beko 7158144600, Руководство пользователя

Страница: 20 / 28

20 / EN
Washing Machine / User Manual
4.3.16 Cancelling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be cancelled. End/
Cancel light will flash continuously to notify that
the programme has been cancelled.
When you turn the Programme Selection knob,
the machine will end the programme but will not
discharge the water inside. When you select
and start a new programme, the newly selected
programme will start depending on the step
the previous programme was cancelled in. For
example, the machine may take in additional
water or continue to wash with the water inside.
C
INFORMATION
• Depending on the step where the
programme was cancelled in, you may have
to add detergent and softener again for the
programme you have selected anew.
4.3.17 End of programme
At the end of the programme, “End” will be
displayed.
1. Wait until the light of the loading door goes
off completely.
2. Switch the programme selection knob to
On/Off to switch off the machine.
3. Take out your laundry and close the loading
door. Your machine is now ready for the
next washing cycle.
4.3.18 Your machine has the
"Pause Mode" function.
After using the On/Off button to switch on the
machine, if you do not start any programme in
the selection step or do not perform anything
else, or if you do not do anything in 10 minutes
after the selected programme has ended, the
machine will automatically switch to energy
saving mode. Also, if your product has a display
that shows programme time, this display will
completely turn off. If you turn the Programme
Selection knob or touch any button, the lights
and the display will switch back to the previous
position. The selections you make when exiting
the energy efficiency mode may change. Check
if your selections are correct before starting the
programme. If necessary, make adjustments
again. This is not an error.
4.4 Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
4.4.1 Cleaning the detergent drawer
Clean the detergent
drawer at regular intervals
(every 4-5 washing cycles)
as shown below in order
to prevent accumulation of
powder detergent in time.
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
2. Lift the rear part of the siphon to remove it
as illustrated. If more than normal amount of
water and softener mixture starts to gather
in the softener compartment, the siphon
must be cleaned.
3. Wash the detergent drawer and the
siphon with plenty of lukewarm water in a
washbasin. In order to prevent the residues to
contact your skin, clean it with an appropriate
brush by wearing a pair of gloves.
4. Insert the drawer back into its place after
cleaning and make sure that it is seated well.
4.4.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
C
INFORMATION
• Repeat Drum Cleaning process in every 2
months.
• Use an detergent / anti-limescale suitable
for the washing machines.
After every washing
make sure that no foreign
substance is left in the
drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.