Beisler 1281/4 Series, Руководство по эксплуатации

Страница: 39 / 48

2-13
The inputs are occupied as follows:
Description Rounded connector (6-pin)
M1 Key mouse backward pin 4
M2 Key for stacker impulse pin 3
M3 Key pulling device up pin 1
M7 Initiator mouse backward pin 1 (input connector)
3.7 Program inputs and outputs
The inputs and outputs can be enabled/disabled on setup page -10. Enabled
inputs and outputs can be programmed.
To program an input or output, position the cursor on the respective icon and
press the Special key. The setup page will be opened.
Hint
The programming of inputs and outputs is not executed program-specific.
The setting is the same for all programs. Modifications effect all sewing
programs.
3.7.1 Setup page of inputs and outputs
OUT F6
STEP
STOP
PRG
800
STEP
700
STEP
A programming is shown for the example of output F6 (displayed in the upper
left corner of the display).
A function must be selected for each input/output, a start delay and duration
must be programmed. The selected function is displayed on the left side in
front of the background „I/O“. The icons will be explained further below.
The start delay is displayed to the right of the left-handed „hour glass“, the
active duration to the right of the right-handed hour glass. The avilable
functions are displayed above the hour glasses in a horizontal row.
Do the following to program an input or output:
1. Position the cursor on the icon of a function in the upper right part of the
display.
2. Press the horizontal arrow keys until the desired function icon is marked.
3. Press the Plus key to select the marked function icon. It will be displayed
in the area „I/O“.
4. Position the cursor on the time value to the right of the left-handed hour
glass icon if you want to program a start delay (in ms) for the selected
function.
5. Press the Plus/Minus key repeatedly, until the desired value is displayed.
6. Position the cursor on the time value to the right of the right-handed hour
glass, where you can program the active time (in ms) for the selected
funtion.
7. Press the Plus/Minus key repeatedly, until the desired time value is
displayed.