BEING Instrument Inc.
847 Palmyrita Ave, Unit A Riverside CA 92507 USA | T: +1 (800) 278-1390 | [email protected] | www.beinglab-usa.com
document number
Setting Temperature & Timer
The unit is ready for use.
Upon turning the unit’s power on, the controller will cycle through these
two start-up screens.
STEP 1:
Turn on unit power
PROG
Area: Displays the program working or setting
group. Controller is capable of programming and storing
up to 7 programs.
STEP
Area: Displays the number of the step within a
program. There are 9 steps available for each program.
TIME
Area: Displays the running time or parameter
value.
TEMP
Area: Displays the measured (actual) temperature
within the oven’s chamber. Also, displays the ambient
room temperature when requested.
SET
Area: Displays the temperature setpoint.
RUN
: Illuminates when the oven’s program is working.
Turns off when program is stopped.
HEAT
: Arrows illuminate and blinks when the oven’s
heater is on. Turns off when heating elements are off .
Visible Alarm
: Illuminates when the program has
completed, has been stopped by user, or when an over
temperature condition occurs. Additionally, when the
visible alarm illuminates an audible alarm will start.
Audible Alarm Disabled
: Illuminates when the user
presses any key or when the unit’s power is turned off .
Keys
Setting
: Starts the programming of the temperature and
run time. Accepts the temperature and run time values.
Shift
: For changing the parameter value being set and
viewing ambient temperature.
Decrease
: Used for setting parameter value, modifi cation
of various values, or start/stop auto-tuning.
Increase
: Used for setting parameter value, or press and
hold for more than 2 seconds to view the remaining
program time.
RUN/STOP
: Press for 2 seconds to run or stop the controller.
STEP 2:
Check ambient temperature.
Press and hold shift key for 4 sec-
onds to view ambient temperature.
Temperature value will blink. Press
and hold shift key for 4 seconds to
return to main screen.
Function also works while program
is running.
Temperature setpoint must be.
a 10
O
C to 200
O
C
a 18
O
F to 392
O
F
STEP 3:
Push setting key
STEP 4:
Input temperature & time values
Press decrease or increase key to set
tenths value. Value will blink as it
is being set.
Press the shift key to move to the
next parameter digits. Each move
will cause parameter to blink.
Press the setting key to accept
temperature setpoint. “End” in TIME
area will change to run time digits.
First digit will blink.
Use decrease or increase key to set
each minute and hour value.
Press the shift key to move to the
next parameter digits.
Upon setting the run time, press
and hold the setting key for 3
seconds to complete the program.
TIME area will return to “End.”
If unit power is on and ambient temperature is known,
start programming process at Step 3.
If changing temperature only,
press and hold setting key
for 3 seconds, change temperature, press setting key, and
press and hold setting key for 3 seconds.
If changing time only,
press and hold setting key for 3
seconds, when temperature blinks press setting key, change
time, and press and hold setting key for 3 seconds.
Safety Messages
Controller Element Overview
STEP 5:
Push RUN key
Pushing the RUN key for 2 seconds,
starts the program. RUN, HEAT, and
run time illuminate.
Pushing the setting key for 3
seconds, starts the programming
process.
The tenths temperature value
blinks.
Press and release to decrease/increase one digit at a time.
Press and hold to rapidly cycle through digits.
Push the circuit breaker’s lever
down to turn on the power to
the oven.
