Page 5
Battery charger
Probe connection
Button functions
1)Button on/off TS1007.
To turn on or off the TESTER, press the button for 5 seconds.
2) Group of navigation buttons on the tester
a) “DOWN” button: Pressing this button will scroll through the pages down. (see instructions 6)
b) “ENTER” button: Pressing the button on page 1 you access to:
1) Check the model of the device connected
2) Serial number
3) Week and year of manufacture
4) The estimated remaining days of working
5) Turn on cycles
6) Alarms detected
7) Corrections carried out
Pressing the “ENTER” button on page 3 (PRINT), you start the printing
Pressing the “ENTER” button on page 4 (TAR 175), is used to change the TAR according to the requirements
by pressing, you will notice the flashing, and pressing “UP” or “DOWN” increases or decreases the value.
Pressing the “ENTER” button on page 5 (NEW), is used to reset the device to the factory data resetting the
counters.
Pressing the “ENTER” button on page 6 (SAVE), is used to save permanently the modified data
c) “UP” button: pressing this button will scroll through the pages to the top. (see instructions 6)
Check the status of the battery.
Pressing simultaneously the buttons “UP” and “DOWN” the word BAT appears on the display followed by three
segments; Full segments: battery charging. Empty segments: low battery
DISPLAY
Il display of TS1007 is alphanumeric and is used to display the following information:
3) Unit of measure “LEL” for explosive gas; “ppm” for the toxic gas, the exchange is done automatically
according to the type of probe.
4) Percentage reading, indicates the quantity of gas dispersed in the environment.
N.B. The word “FAULT” replaces the reading of the percentage of gas in case of failure of the probe.
5) The symbol of “%” turns on only when it is read the explosive gas.
6) Reading page number; the tester contains from 1 to 7 pages according to the model.
7) The icon “CRAWL with a line” turns on when the tester is not connected to the probe tested.
8) The clock icon, indicates that the probe tested is in a wait state “WARMUP”.
9) The directional antenna that contains the item “IR” transmission to the printer.
Viewed from below
9
TS1007
UP Enter Down
Edit
2
%
*
LEL 20
Battery
Charge
Cable
Probe
Print IR
1
2
3
4
5
6
7
8
Components and commands
Antenna IR port
rotating 90 °
label marked
