Beijer Electronics EXTER T100, Руководство по обслуживанию и ремонту

Страница: 26 / 54

Hardware
26 Beijer Electronics, MA00757A
3.7.4 Replacing the Display/Display Cable
The following is needed:
– A new display or a new display cable, see Available Spare Parts .
– A torx T10 screwdriver.
– Two plain screwdrivers.
EXTER K30m
To replace the display you will need a new display including display frame, see
the
Available Spare Parts section.
Follow the steps below:
1. Power off the operator terminal.
2. Follow the instructions under Replacing the Rear Cover to remove the rear cover.
3. Unlock the two flex cable connectors by pressing the connector flanges towards
the cable and disconnect the flex cables from the power card.
The connectors must be unlocked on both sides before removing the cables.
4. Gently press the power card towards the top of the terminal as shown in the
illustration above to release the power card from the power card holders.
Then tilt the bottom of the card away from you.
5. Disconnect the two flex cables and the plain cable on the back side of the power
card and then remove the power card.
6. Insert the two screwdrivers between the display frame and the aluminum casing
illustrated below. Press and bend gently on the display frame to unlock the frame
and tilt up the display frame.
7. Mount the new display unit.
8. Re-assemble the terminal in reverse order.
Note:
Make sure you have adequate ESD protection.
flex cables
power card
pressure points on display frame