Hardware
24
Beijer Electronics, MA00757A
3.7.3 Replacing the Rear Cover
The following is needed:
– A new rear cover.
– A torx T10 screwdriver.
EXTER K30m, EXTER K60c, EXTER T40/T40m and EXTER T60c/T60m
To replace the rear cover you will need a new rear cover, see the
section.
Then follow the steps below:
1. Power off the operator terminal.
2. Follow the instructions
to remove the battery.
3. Remove the rear cover of the operator terminal by loosening the 4 torx screws.
Illustration of EXTER K30m
Illustration of EXTER K60c and EXTER T60c/T60m
Illustration of EXTER T40/T40m
4. Re-assemble with the new rear cover in reverse order.
Note:
Make sure you have adequate ESD protection.
4 x torx screws
4 x torx screws
4 x torx screws
