behringer.com
6
EUROGRAND EG8280USB Assembly Instructions
[2]
S2
Fig. 2.2: Mounting the legs
Hold the pedal board
3)
{[3]}
to the console with the pedals facing towards the
floor. Tighten the board with two bolts (S2) locking the premounted nuts at
the recessed positions of the console as shown in Fig. 2.3.
Attach the supportive metal bars to each side of the pedal board by using
4)
two screws (S1) on each side. Push the bars to the bottom of the console
until they lean firmly against the bottom, without pressing them down
too far. Make sure that the bars are aligned in parallel and fasten the bars,
each with two screws (S1).
S1
S1
[3]
S2
Fig. 2.3: Mounting the pedal board
Disassemble the three pedal bars (S4) by loosening the hexagon spacer
5)
elements and the nuts (S3).
Insert each pedal bar (S4) with the thread pointing towards the console into
6)
the proper cavities. Lock the bars with the nuts followed by the hexagon
spacer elements (S3) as terminators.
S4
S4
S4
1.
2.
Fig. 2.4: Inserting the pedal bars
Place the pedal bars (S4) with the rubber-plated end into the socket of
7)
each pedal.
Adjust the hexagon spacer elements (S3) of each pedal bar by turning the
8)
nut and spacer. The spacing between spacer and switch should be approx.
3/8" (9 mm) for a comfortable playing experience. Make sure all of the
pedal bars have the same spacing to ensure similar operational behavior.
Secure the spacer with the nut after aligning the positions.
S3
Fig. 2.5: Adjusting the spacer elements
Ensure that all screws and bolts have been properly secured.
9)
Caution
!
Be careful when bringing the piano into an upright position. There is
◊
an enormous risk to overbalance the unit when not handled properly,
which may result in damage to the instrument, personal property
or even cause serious injury. Make sure that a minimum of two
persons are involved in accomplishing the next step and follow the
instructions carefully.
Don’t let the entire weight of the piano rest on one leg, when placing it
◊
in an upright position, otherwise the leg might break due to overload.
Place the piano in an upright position. Be absolutely sure to hold the piano
10)
at the positions shown in Fig. 2.6 to minimize the risk of overbalance. Lift the
whole unit, rotate it and put it down on all legs simultaneously.
Fig. 2.6: Setting the piano upright
Remove the foil that covers the console.
11)
Содержание EUROGRAND EG8280USB
Страница 10: ...behringer com...
