– 20 –
behrotest
®
K8 / K12 / K20 / K16 / K24 / K40
0591
11
Taking Off the PTFE Stoppers
Cautiously turn the exhaust collector bottom up so
that the suction nozzles are pointing upwards.
From the suction vessels you want to replace, pull the
PTFE stoppers off.
Turn the exhaust collector to the normal position
again.
Changing the Glassware
On the suction vessel you want to replace, pry the
upper hose clip open with broad pliers and push the
hose clip downwards on the hose.
Cautiously pull the suction vessel out of the viton
hose cutting.
In case you want to replace the collecting tube, you
need to take out all the suction vessels this way.
Insert the new suction vessel into the intermediate
bottom and push the nozzle into the viton hose cut-
ting.
Secure the joint of the hose cutting and the new
suction vessel by pushing the hose clip to the upper
position again.
If need be, shift the collecting tube and the suction
vessels connected to it in such a way that the nozzles
go centered through the borings of the intermediate
bottom.
Lay the crossbars on top of the suction vessels again
and screw them to the intermediate bottom with the
long screws.
Screw the roof panel onto the crossbars again.
Screw the back panel tight too.
Turn the exhaust collector bottom up again and push
the PTFE stoppers on the nozzles.
