2
Diagram
B:
Control
Panel
Set
Start
Auto
Mode
On/off Manual
release
Control Button Descriptions
Mode button:
Press this button once to set automatic time, twice to set pre-soak time, three times to set brew temperature, four
times to set the current clock and five times to calibrate the temperature. The “
” and “
” buttons are used for increasing and
decreasing these mode settings. See instructions below.
On/Off Button
: At any point during operation, press this button to cancel any/ all procedures
Auto Button
: Used to turn on and off the “Automatic start”.
Manual Release Button:
Used to enter the manual release mode and control the release of water in that mode.
To brew coffee
in this mode you should not release water continuously or water will overflow the coffee basket. Alternating 15 to 20 seconds
between water releases is a good place to start.
“
” and “
” Buttons
: Used for increasing or decreasing the time, the brew temperature and altitude.
Set Button:
When setting the automatic start time and current time, it is used for switching between Hour and Minute, and for
switching from °F to °C when setting the brew temperature.
Start Button
: For starting the brewing cycles and calibration.
* Power Saving Sleep Cycle
: The Brazen is programmed with a Power Saving Sleep Cycle. After 5 minutes of inactivity the
system will go into this mode and the screen will dim. Press any button to bring the brewer out of this mode.
Initial Set Up and Cleaning
1.
Remove all packing materials.
2.
Check that all parts and accessories are included and that the brewer is not damaged.
3.
Wipe out stainless steel reservoir with a damp cloth.
4.
Add water (Filtered or bottled water is best) to the calibration fill line. Leave the reservoir lid OFF.
5.
Be sure the carafe and filter basket are in place.
6.
Plug the Brazen Brewer into the power outlet.
7.
Program and Calibrate you brewer
(see following page)
8.
After your full calibration procedure is completed
, fill reservoir to maximum line (1.2L/ 8 Cup) and place
reservoir lid over reservoir.
9.
Press “Start” to run a brewing cycle of water only. This rinses the internal components before the first use. Be
sure carafe and other items are in their proper place(s).
10.
Wash and rinse the removable components (filter basket, gold filter, carafe, and lid) with mild dishwashing
detergent before the first use.
