INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Turn off power supply before attempting to install the unit.
3. Do not use outdoors.
4. Do not let power cords touch hot surfaces.
5. Do not mount near gas or electric heaters.
6. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to
tampering.
7. The use of accessory equipment not recommended by Beghelli USA, may cause an unsafe condition, and will void
the unit’s warranty.
8. Do not use this equipment for other than its intended purpose.
9. Quali
fi
ed service personnel should perform servicing of this equipment.
10. Consult building code for approved wiring and installation.
11. The
fi
xture must be grounded to avoid potential electric shock.
12. SAVE THESE INSTRUCTIONS!
INSTALLATION
1. Extend unswitched 24 hour AC supply of rated voltage to an electrical junction box (supplied by others) installed in
accordance with all applicable codes and standards.
2. Extend wiring from the junction box to the location where the unit will be installed. Leave at least 8 inches of slack
wire at the end of the circuit. This circuit should NOT be energized/live at this time.
3. Remove the lens by placing an appropriate sized
fl
at head screw driver into the snap lock clips and pushing the clips
slightly in and down until they release the lens. This must be completed to each of the four clips (Figure 1).
4. Pull the lens away from the unit. The internal re
fl
ector and chassis can now be removed by placing the screw driver
into the re
fl
ector locking channels and twisting slightly until the clip releases. This must be completed to each of the
four mounting channels (Figure 2). For recessed installation see (Figure 6).
5. Pull the re
fl
ector and chassis away from the back plate to access the electronics mounted on the back.
6. Wall or ceiling installation can be completed by installing screws and washers (supplied by others) with a water proof
cap through the back of the
fi
xture housing (Figure 7).
7. Complete the battery connection by locking the plastic battery connectors together (Figure 4). The lamp my turn on
once the connection is completed, depending on the charge level of the battery.
8. Secure the wires in place and ensure that the AC supply wires have been routed out to the steel electrical box
mounted on the back of the unit.
9. Make the appropriate AC voltage connection (Figure 10)
10. Control of the light output can be achieved with the supplied re
fl
ecting “spoiler” (Figure 8) and for ceiling applications
or where light control is not required the re
fl
ecting “spoiler” can be removed (Figure 9).
11. RE-align the re
fl
ector with the back plate and push together until each locking clip engages.
12. Align the lens with the unit and push in back into place until each lens snap lock clip engages.
13. When the unit is reassembled turn on AC voltage supply.
MAINTENANCE
1. The equipment is to be repaired whenever the equipment fails to operate as intended during the duration test.
Written records of test results and any repairs made must be maintained. Beghelli Inc. strongly recommends
compliance with all Code requirements.
2. Clean lenses on a regular basis.
NOTE: The servicing of any parts should be performed by quali
fi
ed service personnel only. The use of replacement parts
not furnished by Beghelli USA, may cause equipment failure and will void the warranty.
The lamps listed herein when used according to the instructions with this unit are in accordance with the requirements of
CSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.
Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: (800) 726-4316 Tel: (954) 442-6600 Fax: (954) 442-6677
Tempesta™ (TA)
926000294
08/08/2018
