INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2.
1.
Turn off power supply before attempting to install the unit
3. Do not let power cords touch hot surfaces
4. Do not mount near gas or electric heaters.
5. Equipment should be mounted in locations
where unauthorized personnel will not readily subject it to
tampering.
6. The use of accesso
ries
not recommended by Beghelli, may cause an unsafe condition, and will void
the warranty.
7. Do not use this equipment for other than its intended purpose.
8. Qualified service personnel should perform servicing of this equipment.
9. Consult building code for approved wiring and installation
10. The fixture must be grounded to avoid potential electric shock
11. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
12.
SAVE THESE INSTRUCTIONS!
INSTALLATION (standard surface wall)
1. Extend unswitched 48 hour AC supply of rated voltage to an electrical junction box (supplied by others) installed in
accordance with all applicable codes and standards.
2. Extend wiring from the junction box to the location where the unit will be installed. Leave at least 8 inches of slack
wire at the end of the circuit. This circuit should NOT be energized/live at this time.
3. Remove the lens by placing an appropriate sized flat head screw driver into the snap lock clips and pushing the clips
slightly in and down until they release the lens. This must be completed to each of the four clips (Figure 1).
4. Pull the lens away from the unit. The internal reflector and chassis can now be removed by placing the screw driver
into the reflector locking channels and twisting slightly until the clip releases. This must be completed to each of the
four mounting channels (Figure 2).
5. Pull the reflector and chassis away from the back plate (Figure 3) to access the electronics mounted on the back.
6.
7.
Surface, wall or ceiling installation can be completed be installing screws and washers (supplied by others) with a water
proof cap through the back of the fixture housing (Figure 5).
EM and AC EM units only:
Complete the battery connection by plugging the 2-position battery connector into the
PCB (Figure 4). Two-wire wall switch control is available in ACEM unit (Figure 8). For multiple fixtures controlled by a
single wall switch, connect same polarity to the same side of switch.
8. Secure wires and ensure that AC supply wires have been routed to the steel electrical on the back of the unit.
9. Make the appropriate AC voltage connection (Figure 8).
10. Re-align the reflector with the back plate and push together until each locking clip engages.
11. Align the lens with the unit and push in back into place until each lens snap lock clip engages.
12. When the unit is reassembled turn on AC voltage supply.
Tempesta™ LED
ECO (TA)
Release lens
Figure 1
Figure 4
Circuit Board
Push battery
connector(s) into
Battery(ies)
Figure 5
screws & washers
not supplied
Waterproof cap
Figure 2
Figure 3
Battery
Release
refractor
Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: (800) 726-4316 Tel: (954) 442-6600 Fax: (954) 442-6677
