Mounting instructions
230V/50Hz
Series
84-00
BEGHELLI - ELPLAST, a.s.
Poříčí 3A, 603 16 Brno
Česká republika
Tel.: +420 531 014 111
Fax: +420 531 014 210
č
. návodu: 1494.0436
sklad. položka: E09060272
MOUNTING PROCEDURE:
Fixture is designed for recessed installation into ceiling system - below mounting. Maximum thickness of the ceiling module for the mounting hole is 35 mm. To attach
lthe fixture to the ceiling system is 12 holes with a diameter of 6 mm in the frame of the fixture. The fixture is designed for access only from the upper side. After attaching
to the ceiling module connect to the mains. For the power cable is used gland PG13,5.
TECHNICAL DETAILS:
Rated voltage: 230V, 50Hz
Lamp: fluorescent lamp T8 (socket G13), fluorescent lamp T5 (socket G5)
Degree of protection: IP 54 (84-00), IP65 (84-01)
Electrical accident protection class: I
Ambient temperature: 25°C
Suitable for direct mounting onto a normally inflammable basis - F: yes
The luminaire satisfies requirements of all standards in force.
WARNING:
- Check whether the mains specification satisfies the data mentioned on a luminaire plate before connecting it to the mains.
- Contact the customer service authorised centre for replacement of fluorescent tubes and batteries and for repairs, and insist on using original spare parts only. Not
satisfying these instructions could result in loss of luminaire safety or in loss of warranty.
- This luminaire should only be used for a purpose for which it was manufactured. Any other usage shall be assumed to be unsuitable and therefore dangerous. The
manufacturer bears no responsibility for any injury caused to persons or animals or for property damages caused by improper, faulty or inadequate usage.
- A luminaire must be disconnected from the mains before any interference with a luminaire, service or maintenance. An expert person, in terms of valid regulations
concerning the competence to activities, should only perform these actions.
- The luminaire may only be connected to the mains, whose installation and protection satisfies standards in force.
WARRANTY:
All products of the company Beghelli - Elplast, a.s. are made of the highest quality materials, thoroughly tested and guaranteed by the manufacturer to be free of defects
in terms of existing legislative regulations. This warranty becomes invalid if mounting is not executed according to the instruction manual, the luminaire is damaged or
modified or repaired by an unauthorised service centre of the company Beghelli - Elplast, a.s.
The product cannot be disposed as unsorted municipal waste. It must be collected separately to prevent negative environmental impacts. In accordance
with the procedures of Directive 2002/96 and relevant national laws and regulations adopted pursuant to this Directive on the disposal of waste at the end
of the life cycle of the product, any violation is sanctioned by law. Please inform yourselfabout the local separate collection system for electrical and electronic
products.
84-01
454
1346
380
380
380
305
93
64,5
12x
Ø
6
111,5
354
387
1250
113
77
410
1305
84-003/336* (IP54)
84-003/354* (IP54)
84-003/436* (IP54)
84-003/454* (IP54)
84-013/336* (IP65)
84-013/354* (IP65)
84-013/436* (IP65)
84-013/454* (IP65)
