41
CAUTION!
When installing the appliance ensure optimal heat
radiation to maintain the operating safety.
CAUTION!
The wall and the reach of the heat radiation above the
worktop must be made of heat-resistant materials.
CAUTION!
To avoid any damage, the sandwich layer and adhesive
must resist heat.
The customer is responsible for the installation. If the
manufacturer´s help is needed to repair any damage due to
improper installation, this repair work is not covered by the
guarantee. Improper installation may cause serious personal
injuries and/or property damage. The manufacturer cannot be
held liable for such injuries or damages.
2.1 Unpacking and positioning
(1)
Unpack the appliance carefully. Dispose of the packaging as
described in chapter waste management.
(2)
Completely remove the transport-protection. Be very
careful and do not use any aggressive or abrasive detergents
to remove residuals of the transport-protection.
(3)
Check that the appliance and the power cord are not visible
damaged.
(4)
Do not install the appliance in a place where it may come in
contact with water or rain; otherwise the insulation of the
electrical system will be damaged.
(5)
Connect the appliance to the mains properly.
2.2 Pre-installation requirements
The worktop must be made of heat-resisting material.
Structural elements should not interfere with the installation
area.
To install the hob, the thickness of the worktop must be
between 40 and 50 mm.
The installation must meet the safety requirements as well
as the legal rules and regulations.