4
4.
Add BeeSecure® Door and Window Magnetic Sensor Set
Before configuration, please make sure the BeeSecure® Hub (purchased separately) is in active mode
(For more information, please check the manual for BeeSecure® Hub), in the meantime the sensor unit
should also be turned on. The distance between the sensor set and the hub should be no more than
100cm during configuration.
Step 1
Open the BeeSecure® App: tap “+” at the right top corner of the Home page. Select
“Door/Window Sensor”. If the hub has not been added yet, the App will guide you to add the hub
first. Follow the in-App instructions to add the hub.
Step 2
Configure the hub: Press the button on the hub. The LED indicator will flash in green, which
means the hub is ready to add a new device
Step 3
Configure the sensor: Press and hold the button of the sensor unit until the light flashes
blue
Step 4
When you have successfully added the sensor, the hub LED indicator will light in constant
green (without flash). In the meantime, you will immediately receive the following message on the
app “Device has been added”
*If the brightness of the sensor light is weak, it indicates no sufficient battery power. It may result in
connection failure. Please change the battery and try again.
5.
Install BeeSecure® Door and Window Magnetic Sensor Set
After configuration, the sensor can be installed within 20m from the hub. Try to align the triangle
arrows of the sensor unit and the magnet during installation. During the installation, no external tools
are needed. It is recommended to install the sensor unit on a fixed surface, e.g. door frame, window
frame, and the magnet on the movable surface e.g. (door, window). Make sure the installation gap
between the sensor unit and magnet is no more than 10mm when the door/window closes). If the
frame is made of metal, please align the magnet and the sensor unit as close as possible since there
could be some influence because of the content of the steel.
Step 1
Install the sensor unit: Peel off the protective film at the back of the sensor unit, and stick
to the door or window frame. Make sure the surface is clean and dry.
Step 2
Install the magnet: Stick the magnet on the door or window.