BEER Uno Top Hot, Инструкции по установке и запуску

Страница: 10 / 25

Beer Grill AG Beer Grill GmbH
Allmendstrasse 7 Tel. +41 (0)56 618 7800 Körnerstrasse 14 a Tel. +49 (0)71 61 659 876 info@beergrill.com
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849 D
– 79539 Lörrach
Fax +49 (0)71 61 659 879 www.beergrill.com
Seite 10
Do not run the Uno Top Hot with empty water bins.
Fill water bins up to the marks with water (for wet run) or replace bins by universal frames
(for dry run). Use decalcified water only!
If you do not use decalcified water, we recommend adding 1 tablespoon of vinegar to the
water. A higher concentration or the use of other additives such as chemical agents are
forbidden, as this could cause damage to the material and spoilage of the steamed food
.
Attention! Set lower heating elements max. on level 5.
Preparation: Fill water bin up to the marks (left and right side) with warm water.
Recommendation:
Use decalcified water only.
Switching on unit:
Lower heating elements
Set energy controller (1) on requested level.
Heating power
0 = off, 1 = min. power, 12 = max. power,
pilot light (2) orange on.
Cold/warm light in upper part
Switch on rocker switch (3), selector switch for choosing cold or
warm light (4).
Dimmed version
Additional to the selection of warm light, turn dimmer knob (5) to
requested level (1-5).
Heating power
0 = OFF, 1 = 50% power, 5 = max. power
Micro fuse (6):
Electric protection to dimmer control
Attention! Use only slow micro fuses 2A / 250 VAC.
Danger - HOT - do not touch!
The heating element under the ceran glass reaches its working temperature in a short time.
Ceran glass, base plate and lower part of water bins become very hot.
3.1 Option Timer - check water level
When working with water bins, always fill them with water.
Assure to turn the timer knob to the right until it stops.
After a set time of maximum 120 minutes, the lamp starts to flash and the bottom-heat turns
automatically off. Check the water level and add water if necessary. Afterwards wind the
timer again. The bottom-heat will turn on again.
!