Beer Grill AG
Beer Grill GmbH
Allmendstrasse 7
Tel. +41 (0)56 618 7800
Körnerstrasse 14 a
Tel. +49 (0)71 61 659 876
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849
D
– 79539 Lörrach
Fax +49 (0)71 61 659 879
www.beergrill.com
Seite 6
Muti-Timer Operation
Start timer
By briefly pressing the
Start/Stop
button, the timer starts. The remaining time is counted down
in seconds and the colon flashes in the display.
Pause timer
If the
Start/Stop
button is pressed again during the timer cycle, the sequence is interrupted and
the display flashes. To continue the timer cycle press the
Start/Stop
button again briefly.
Cancel timer
If the
Start/Stop
button is pressed for 3 seconds after start or pause, the timer cycle is
cancelled and the display changes to "00:00 ". After releasing the
Start/Stop
button, the initial
operation time is shown.
Timer stop
After completion of the timer cycle the buzzer sounds for 5 seconds and the display flashes
"00:00". The buzzer can be acknowledged with the
Down
button. Note that the acknowledgment
is required before a restart or before time settings. The duration of the buzzer sound can be
adjusted. As well the buzzer can be deactivated completely.
Timer selection
The seven adjustable operating times can be selected with the respective button. Each press
will switch to the following operating time and the selection is indicated by the corresponding
LED 1...7. Upon change, the new operating time is ready for launch. The timer selection is
saved after power off.
Temporary setting
After selecting one of the provided operating times it can be adjusted using the up or down
button on the momentary needs, without saving the new value. The timer LED goes off to
indicate the temporary operating time. This time is valid until a new operating time 1...7 is
selected (or at mains off). The new operating time can be started as often as required.
Note that adjustment during the current timer cycle is indeed possible, but the new setting is not
yet effective for the current timer.
How to adjust operating times
If you press the
Up
or
Down
button to adjust an operating time there is a short delay after which
the setting is unlocked. This “adjusting mode” is indicated by the flashing colon in the display.
The value can now be set by tapping or permanently pressing the button. If no button is pressed
for more than 3 seconds, the controller returns to the initial state and the colon in the display
stops flashing.
Programming operating times
To permanently set the operating times, press the
Prog
button for 1 second. The LED of the
current selection flashes and indicates that the programming mode is accessed. The selection
and adjustment is now in the same manner as above, however, the values now are stored in the
permanent memory when returning to initial state.
Return to initial state takes place by pressing the
Prog
button, or automatically after 5 seconds.
