5. CAMERA INSTALLATION
Remove the burner plate behind the slot in order to identify the most appropriate location to left, right or
directly on the pilot bracket plate. In the trunk, find out how to wire the camera, allow the setting of the
camera and connect it to the son of the original vehicle as shown on previous pages.
After choosing the best camera position, drill a hole with a diameter of 6 mm.
We recommend that you protect the holder of an adhesive (adhesive type painter) to avoid damage during
drilling. A light sanding may be necessary after drilling the hole to deburr the hole contour, and to avoid
damaging the cable insulation of the camera.
Remove the bolt from the threaded shank of the camera, pass the thread of the camera (microphone
connector) through the hole. Collect this thread in the trunk, insert the bolt and screw it onto the threaded
rod. Clamping must be strong enough to ensure good sealing and holding the camera, attention once not over
tighten which could damage the stem filtée camera.
16
1
2
3
The camera is positioned above the plate without obscuring, and should be placed closest to the center of the vehicle as possible.
Содержание RW050RF
Страница 20: ......
