Bee-Ball Optimum, Инструкция по эксплуатации

Страница: 4 / 8

3
Assembling Your Stand
1
Attach Ring to Backboard
You will need:
Hoop/Ring (part 2)
Backboard (part 1) 4 x Bolts, Nut & Washers D (M10 x 40mm)
First, remove the metal case from the back of the ring using a crosshead screwdriver.
Fix the Hoop/Ring (part 2) to the front of the Backboard (part 1) using Bolts, Nuts & Washers D.
The bolts go through the back of the backboard then through the ring and are fixed in place using the nuts. Now
put the metal case back on the ring.
2
You will need:
Parts as assembled in Step 1
Backboard Braces (parts 4{S} & 5{T}) 4 x Bolts, Nuts & Washers C (M12 x 60mm)
Attach the Backboard Braces (parts 4 & 5) to the backboard using four Bolts, Nuts and Washers C. Braces S (parts 4)
go at the top of the backboard - furthest away from the ring.
Attach using the Bolts/Nuts in this order:
Bolt > Washer > Brace > Washer > Backboard > Washer > Nut
Please Note: These bolts need to be tightened to the right level. If they are too tight, it will be impossible to adjust
the height of the backboard and too much pressure will be put on the stand.
Tighten the nuts up until you can feel a resistance and then loosen a little bit, the braces should move freely.
Attach Backboard Braces
top of
bottom
S
T
backboard