Jeep Wrangler TJ Bedrug/BedTred
Interior Installation Instructions
FIGURE 9:
9.
Repeat steps 5 thru 8 for the passenger side
wheel well. Note the cutout necessary on the
passenger side only for the rear door sensor.
(
Fig. 9
)
FIGURE 10:
FIGURE 11:
INSTALLING CARGO AREA FLOOR
Note:
For jeeps with a rear seat, trimming will be necessary to fit around seat mount and seat belt
attachment points. There are score lines on the back of the part to use as a guide.
10.
With the rear seat in the up position, or removed, place the floor piece into position. (
Fig. 10
)
Cut holes in center of floor piece if seat belts are present. Lift the floor piece from the rear and
pull the seat belts thru the holes. (
Fig. 11
)
11.
If tie downs are preferred to be accessible, cut holes and slits as desired using score lines on the
underside of floor or cut out using your tie downs as a guide. (
Fig. 12
)
12.
Now pull up floor piece from rear of vehicle to access the hook fastener. Clean surface with alcohol
then remove the film backing from all of the locations behind the rear seat and roll the floor back into
place. Firmly press the top surface to ensure adhesive attachment. (
Fig. 13
and
Fig. 14
)
FIGURE 12:
FIGURE 13:
FIGURE 14:
BEDRUG, INC.
Q
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
Q
800-462-8435
Q
www.bedrug.com
TJ97RINST Rev. 1 8/30/2012
Page 3 of 6
