Congratulations on choosing the finest interior flooring kit available for your Jeep.
The Bedrug/Bedtred material is mold and mildew resistant, easily cleaned with water
& household cleaning chemicals and extremely resistant to most chemicals.
Ê
UÊ
Kit Contents:
Driver side front floor, passenger side front floor,
rear passenger floor, heat shield material, hook fasteners,
and instruction sheet.
Ê
UÊ
Tools needed:
Phillips screwdriver, utility knife, soap, water,
and rubbing alcohol.
Jeep Wrangler TJ Bedrug/BedTred
Interior Installation Instructions
PREPARATION
1.
Read all instructions before beginning installation.
2.
Remove old Jeep flooring material (if equipped).
3.
Wash and dry the floor pan areas thoroughly.
4.
Place the hook fasteners on each piece of loop sewn on the
back side of the BedRug. For BedTred installation, place the
hook fasteners to the loop surface on the underside of the
BedTred. Use drawing on
Page 4
for proper location.
5.
Pre-install provided heat shields on underside of the two
front pieces in areas (
see Page 4
), using the locator marks.
(
Fig. 1
thru
Fig. 4
) Note: Passenger side heat shield is
the larger of the two pieces.
IMPORTANT:
Jeep floor should be at least 68°F (20°C) for maximum
adhesion. Clean all areas with rubbing alcohol before applying tape.
When removing backing, do not touch adhesive. If both front and rear
kits were purchased be sure to install the rear cargo area first.
FIGURE 1:
PASSENGERS SIDE
FIGURE 3:
DRIVERS SIDE
FIGURE 2:
PASSENGERS SIDE
FIGURE 4:
DRIVERS SIDE
FRONT KIT:
BRTJ97F and BTTJ97F
BEDRUG, INC.
Q
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
Q
800-462-8435
Q
www.bedrug.com
