Congratulations on choosing the finest interior flooring kit available for your Jeep.
The BedRug/BedTred material is mold and mildew resistant, easily cleaned with water
& household cleaning chemicals and extremely resistant to most chemicals.
• Kit Contents: Driver side front floor, passenger side front floor,
mid section, rear floor (4-door kits only),
heat shield material, hook fasteners, and instruction sheet.
• Tools needed: Flathead screwdriver, scissors, soap, water,
and rubbing alcohol.
PreParation
1.
Read all instructions before beginning installation.
2. Remove old Jeep flooring material (if equipped).
3. Wash and dry the floor pan areas thoroughly.
4. Place the hook fasteners on each piece of loop sewn on the back side of the BedRug. For BedTred
installation, place the hook fasteners to the loop surface on the underside of the BedTred.
Use drawing on Page 4 for proper location.
5. Cut the hook fasteners with tape backing to match the
length of the loop sewn on the underside of each
BedRug piece. Pre-install provided heat shields on
underside of the two front pieces in areas (see Page 4),
using the locator marks. (Fig. 1) Note: Passenger side
heat shield is the larger of the two pieces.
IMPORTANT: Jeep floor should be at least 68°F (20°C)
for maximum adhesion. Clean all areas with rubbing alcohol
before applying tape. When removing backing, do not touch
adhesive.
BEDRUG, INC.
n
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
n
800-462-8435
n
bedrug.com
2-DOOR
kIT
4-DOOR
kIT
FIguRe 1: HEAT SHIELDS
NOTe: If you have pur-
chased both a front and
a rear kit, it is recom-
mended to install the
rear kit first.
Jeep Wrangler Jk BedRug/BedTred
Interior Installation Instructions
Jk
BRJK07F4, BRJK07F2,
BTJK07F4, BTJK07F2
FRONT kITS:
BR-BTJK07FINST
REV. 1 8/16/2013
Page 1 of 4
