2mm
Screw 1
Screw 2
Screw 3
Screw 4
Step 10
Hinge adjustment
•
Screw 1 is used for gap adjustment
between cabinet end and door.
•
Screw 2 is used to secure hinge to
end.
•
Screw 3 and 4 are used for gap
adjustment between cabinet top and
door as well as to secure hinge plate
to cabinet end.
The following instructions should be followed
to adjust hinges if the gap between the door
and cabinet end is too wide or narrow:
1. Start from the top hinge.
2. Loosen screw 2 by turning screw in
an anti-clockwise direction.
3. Now turn screw 1 in a clockwise or
anticlockwise direction depending on
which way the door needs to be
moved (the amount to turn this screw
is determined by the width of the gap
between the cabinet end and doors).
4. Tighten screw 2 by turning in a
clockwise direction.
5. Repeat these steps for the bottom hinge.
6. Repeat for the other door.
7. Check gap between cabinet door and
cabinet end (should be approx 2mm), if
not same, repeat steps 1 to 6.
To adjust the gap between cabinet top and door,
loosen screw 3 and 4 of top and bottom hinge by
turning screws in anticlockwise direction. Adjust
the gap between cabinet top and top of the door.
Once adjusted, tighten the screw 3 and 4 by
turning in clockwise direction.
Page 8 of 9
28/04/2009
Revision 3
