This guide will assist you with manual programming of the Bed-Check
®
Classic-Check
®
control unit.
More detailed manual programming instructions can be found in the User’s Guide booklet.
For programming, only the control unit and power cord are needed. (Neither a Sensormat
®
nor the nurse call
cord need to be plugged in during programming.)
Arming/Disarming System
Press and release the RESET button to go from MONITOR to HOLD, or
from HOLD to MONITOR, or to silence an alarm. Please note that if the
system is on HOLD, it will reset itself and resume monitoring if weight is
placed on the Sensormat
®
. In addition, if the RESET button is pressed to
put on HOLD and weight remains on the Sensormat
®
, the unit will return
to monitoring mode in 25 seconds.
SETTINGS - Any of the following setting changes may be made independently of the others.
We recommend setting tone before volume, as some tones may seem louder than others.
Day/Night Mode Settings
Press and release DAY/NITE button to switch between DAY and NITE
modes. NITE mode is indicated by a blue light in the splash guard.
Alarm Delay Settings
Press and release the ALARM DELAY button to adjust the alarm delay to
1, 2, or 3 seconds.
R
Bed-Check
Reducing the Risk of Falls Through
Innovative Technology Since 1978
R
Bed-Check
®
Quick Programming Guide
PO Box 80238, Lincoln, NE 68501 • Toll Free 800-523-7956 • Fax 402-475-4023 • www.bedcheck.com
© 2008 Stanley Security Solutions, Inc. DOC-02-70000-AA
®
Press and release
Press and release
DAY
Mode
NITE
Mode
Press and release
1 second
2 seconds
3 seconds