Beckman Coulter Biomek 3000, Быстрый старт

Страница: 28 / 54

2-14 Learning to Create Methods for the Biomek® 3000
Beckman Coulter, Inc.
2.5 Configuring a Move Labware Step
If your instrument configuration does not include a
gripper tool, you cannot move labware; continue to
Section 2.6, Using the Finish Step .
The
Move Labware
step automatically changes tools to
the gripper tool and moves labware from one position on
the Biomek 3000 instrument deck to another position.
Move Labware can also be used to remove labware
from the deck by placing it in an appropriate disposal
position, or to an external hardware device without
halting the Biomek 3000 instrument or the method.
Note: Refer to the Biomek Software User’s Manual,
Chapter 15.4, Move Labware Step .
To configure the Move Labware step to move your
Dest1 labware at position P6 to another deck position:
1. Insert a Move Labware step into the Method View.
2. In Move labware from , select P4 from the drop-down menu.
3. In Move labware to , select P6 from the drop-down menu. The main editor
should now look like Figure 2-11.
Figure 2-11. Configured Move Labware step
The Move Labware step configuration is complete. Now move on to Section 2.6,
Using the Finish Step , to learn how long the method will take to run.
Gripper Tool
The gripper tool is a
specialized tool that is
loaded onto the head
assembly and allows
the Biomek 3000
workstation to grasp and
move labware around
the Biomek 3000 deck.
Refer to the
Biomek®
3000 Laboratory
Automation Workstation
User’s Manual,
Chapter
3, Gripper Tool .