Beckhoff KM2604, Документация

Страница: 12 / 19

Product overview
KM2604 and KM2614 12 Version: 2.1.0
Four-channel relay module, 230 V
AC
, 16 A
The KM2604 and KM2614 terminal module combines 4 pluggable power relays (ZB2601 or ZB2602) in one
fieldbus module. The high switching capacity of 16 A at 230 V
AC
enables direct mains connection of
consumers with high current consumption. The relays are positioning at the top and can therefore be
exchanged easily.
The KM2614 terminal module enables each relay to be manually switched to the ON status. A seal indicates
the initial manual operation.
2.3 Technical Data
Technical Data KM2604 KM2614
Number of relays 4 change-over contacts
Manual operation no at the relays
Rated switching voltage 250 V
AC
, 30 V
DC
Starting current max. 30 A
Continuous current max. 16 A
Breaking current max. 16 A
Minimum permitted load 5 mA (at 10 V
DC
)
Mechanical switching cycles
see relay data [ } 13]
Electrical switching cycles
see relay data [
}
13]
Power supply for the electronics via the K-bus
Current consumption from the K-bus typically 15 mA
Current consumption from the relay power supply
(24 V
DC
)
typically 50 mA for each active relay
Width of a bus terminal block
maximum [
}
14] 64 Bus Terminals/terminal modules
or 80 cm
Electrical isolation 1.5 V (K-bus/signal voltage)
2.5 kV (rated surge voltage for overvoltage category
III)
Configuration No address or configuration settings
Bit width in the output process image 4 outputs
Dimensions with relay (W x H x D) approx. 99 mm x 100 mm x 62 mm (width aligned:
96 mm), see
dimensional drawing [
}
14]
Weight (with 4 relays) approx. 250 g
Permissible ambient temperature range during
operation 0°C ... + 55°C
Permissible ambient temperature range during
storage -25°C ... + 85°C
Permissible relative air humidity 95 %, no condensation
Mounting [ } 15]
on 35 mm mounting rail according to EN60715
Vibration / shock resistance conforms to EN 60068-2-6 / EN 60068-2-27
EMC immunity / emission conforms to EN 61000-6-2 / EN 61000-6-4
Protection class IP20
Installation position variable
Approval CE