Beckhoff CPX27 0010 Series, Инструкция по установке и эксплуатации

Страница: 19 / 39

Product overview
CPX27xx-0010 19 Version: 0.2
4.3.3 USB output (X105 - X108)
X105, X106, X107, X108
USB Type-A twin circuit board mounting (FCI 72309-0030B USB Double Receptacle A-Type)
The four USB interfaces ( X105 - X108 , connector type A) are used for connecting peripheral devices with
USB connection. USB2.0 standard is supported.
Pin Signal Pin Signal
1 5V 3 D+
2 D- 4 GND
4.3.4 DVI-I out (X109)
X109
The DVI connection ( X109 ) is used for transferring the video signal. DVI-I standard is supported.
Table 3: DVI-I interface X109, pin assignment.
Pin Assignment Pin Assignment Pin Assignment
1 TMDS Data 2- 9 TMDS Data 1- 17 TMDS Data 0-
2 TMDS Data 2+ 10 TMDS Data 1+ 18 TMDS Data 0+
3 TMDS Data 2/4 Shield 11 TMDS Data 1/3 Shield 19 TMDS Data 0/5 Shield
4 not connected 12 not connected 20 not connected
5 not connected 13 not connected 21 not connected
6 DDC Clock 14 + 5V Power 22 TMDS Clock Shield
7 DDC Data 15 Ground ( +5V, Analog H/
V Sync) 23 TMDS Clock +
8 Analog Vertical Sync 16 Hot Plug Detect 24 TMDA Clock -
4.3.5 Ground
Malfunction possible with missing ground connection
A proper ground connection of the device is absolutely necessary for the correct function of the
touchscreen.
The Panel PC is grounded via the screw connection ( Ground ).
A wire cross section of min. 4 mm
2
is required.