Beckhoff CP39 Series, Руководство пользователя

Страница: 25 / 52

Commissioning
CP39xx 25 Version: 3.1
Table 12: Ordering options: Film fitted ex works
Ordering option Description
C9900-T217 Adhesive protective film for Panel PCs and Control Panels with 7-inch display, for
fitting onto the glass pane ex works
C9900-T218 Adhesive protective film for Panel PCs and Control Panels with 12-inch display, for
fitting onto the glass pane ex works
C9900-T237 Adhesive protective film for Panel PCs and Control Panels with 12.1-inch display, for
fitting onto the glass pane ex works
C9900-T219 Adhesive protective film for Panel PCs and Control Panels with 15-inch display, for
fitting onto the glass pane ex works
C9900-T220 Adhesive protective film for Panel PCs and Control Panels with 15.6-inch display, for
fitting onto the glass pane ex works
C9900-T221 Adhesive protective film for Panel PCs and Control Panels with 18.5-inch display, for
fitting onto the glass pane ex works
C9900-T222 Adhesive protective film for Panel PCs and Control Panels with 19-inch display, for
fitting onto the glass pane ex works
C9900-T223 Adhesive protective film for Panel PCs and Control Panels with 21.5-inch display, for
fitting onto the glass pane ex works
C9900-T224 Adhesive protective film for Panel PCs and Control Panels with 24-inch display, for
fitting onto the glass pane ex works
Proceed as follows to attach the protective film to the touch screen:
1. For fitting the film choose a location that is as dust-free as possible.
2. Thoroughly clean the surface of the device to be fitted with the film and remove all grease residues.
3. Detach the film from the backing at the short edge and place it on the surface.
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð
The film is now fitted.
Commissioning
To use the Control Panel, you must first put it into operation. The first step is to transport the device to is
operating location and unpack it. This is followed by mounting the device on the mounting arm, connecting
the cables and power supply, and finally switching on the Control Panel. Since the Control Panel does not
have its own power switch, switching the power supply on and off also switches the Control Panel on and off.