Beckhoff CP32 -2 -0020 Series, Руководство пользователя

Страница: 19 / 45

Commissioning
CP32xx-2xxx-0020 19 Version: 1.1
4.2.2 Mounting arm installation
NOTE
Extreme environmental conditions
Extreme environmental conditions can cause damage to the device.
• Avoid extreme environmental conditions.
• Protect the device against dust, moisture and heat.
Observe the following points when mounting the Panel PC on the mounting arm:
• Place the Panel PC in such a way that reflections on the screen are avoided as far as possible.
• For the correct installation height, use the position of the screen for guidance. This should always be
optimally visible to the user.
• Do not expose the Panel PC to direct sunlight.
Mounting on the mounting arm
Four different mounting arm options are available (see chapter 4.2 Mounting [
}
16] ). Depending on the
selected mounting arm, you must proceed differently in order to mount the device on the mounting arm via
the mounting arm adapter. Figure 12 shows the procedure as an example for the C9900-M803, C9900-M804
and C9900-M805 mounting arms.
Proceed as follows to mount the Panel PC on the mounting arm:
1. Remove the lower screw of the mounting arm adapter (Section A).
2. Hook the device into the mounting arm at an angle with the upper screw (section B).
3. Swivel the device into a straight position so that the mounting arm adapter and mounting arm are directly
on top of each other (Section C).
4. Insert the previously removed screw into the mounting arm adapter again so that the adapter is fastened
to the mounting arm (section D).
5. Tighten the screw.
ð You have now mounted the Panel PC on the mounting arm.
A B C D
Fig. 12: CP32xx_mounting on mounting arm, variant 2
If you have chosen the C9900-M802 mounting arm or if you want to mount the device a little lower on the
C9900-M803 mounting arm, you will have to proceed for the mounting as shown in Figure 13:
1. Remove both screws from the mounting arm adapter (Section A).
2. Place the mounting arm adapter over the corresponding holes in the mounting arm (section B).
3. Insert the two screws into the mounting arm adapter again so that the adapter is fastened to the
mounting arm (section C).