Becker CentronicPLUS SC811 PLUS, Руководство по сборке и эксплуатации

Страница: 23 / 60

With an SWCxxxPLUS transmitter
With brand new products, devices from another installa-
tion or products that have been restored to factory set-
tings, programming mode must be established before-
hand (see Establishing programming mode).
Bring the transmitter as close as possible to the sensor to be pro-
grammed.
3s
Press the programming button on the transmitter for 3 seconds. The
transmitter performs a search and the LED ring continuously changes
colour. The transmitter then switches to receiver selection and selects
the sensor/receiver with the best connection quality.
▻ The sensor/receiver confirms.
If you do not receive confirmation from the required sensor, you can
press the
/ button to toggle between the available sensors/receivers
until the indicator lamp on the required sensor flashes 3 times to
confirm.
▻ The transmitter displays the current assignment status via the
LED ring.
Assignment status
Lights up yel-
low:
The sensor/receiver is not yet part
of the installation or is in the as-de-
livered condition .
Briefly pressing the STOP but-
ton adds the device to the install-
ation and updates the assignment
status.
Lights up blue: The receiver is not assigned to the
selected channel.
Lights up green: The receiver is assigned to the se-
lected channel.
Lights up white:
Centronic PLUS sensor selected.
Lights up red: No receiver located.
Press the STOP button on the transmitter to change the assignment
status of the selected receiver. If the receiver is still not assigned to the
selected sensor, it will now be added.
▻ The sensor lights up accordingly to confirm the new assign-
ment status.
▻ The sensor is now part of the installation.
23 - en