1. Setting the release angle (optional)
Caution
The release angle may only be set by a specialist in accord-
ance with the specific features of the articulated-arm awn-
ing.
1. Open the controller and remove the PCB.
2. Set the release angle on the rotary switch.
012
3
4
56
7
8
9
Rotary switch for the release angle
3. Slide the PCB back into the controller and close the cover.
Ensure that the PCB is completely pushed in. After
3 seconds, the controller is ready for operation again.
4. This completes the setting process.
The factory default is 0 (off).
The release angle setting is applied once the initial angle of
inclination is set (Section 5).
22 - en