Installation
Check that the transmitter and receiver are functioning perfectly prior to installation in
the desired location. Open the cover of the control unit. Unplug and remove the “pulse”
button from the control unit and carefully place the cover to one side. Remove the re-
quired cut-outs in the bottom part of the housing.
Cut in at the edges to make the cut-outs easier to remove.
Install the control unit at a height suitable for operation (at least 1500 mm above the
ground). Mount the housing with 4 screws (max. diameter of screw head 7.5 mm) in-
serted through the holes provided in the corners. Plug the cable from the cover back on
and set the DIP switch on the motherboard according to your requirements. You can
now close the control unit.
8
