Menu Overcharge:
In this menu the overcharge counter is indicated. At this point the counter cannot be cleared.
The counter will be reset in the menu „reset water“. From approx. 500 Ah on, the water
servicing should be carried out. ATTENTION: with older vehicles the board computer
delivers no accumulator data (no overcharge counter information).
Menu maintenance charge
Here the maintenance charge can be set. With the next charging process this is carried out.
The fact that the putting of the charge was successful, can be recognised by 3 horizontal lines
behind the maintenance charge. If the charging cable is stuck on afterwards and the charge
runs, behind the 3 horizontal lines a twiddle sign can be seen. This registers that the voltage is
present and the car is charging. In the main menu you can see the current with a negative
sign.
The menus balance charge and Init-charge behave the same.
Attention: Do not use the function Init charge, unless you have new accumulators which must
be formatted.
Menu cancel charge
Up to the version 1.7 this function does not work correctly. If you have put falsely a charge
and like to clear it, draw the main fuse of the car. From version 1.8 this function works
correctly.
.
Menu Read Errors
With this menu the errors can be read.
Menu Clear Errors
In this menu the errors can be cleared. However, permanent errors will appear again. Only
sporadic errors will disappear. If you have permanent errors contact an expert.
T
HE
W
ATER
-
R
EFILLKIT
To refill water to the accumulators a special connection adaptor and a water container
available at Citroen are required. Because these costs approx. 60 euros a Water – Refillkit is
offered by me optionally. This Kit contains the connection adaptor and the inlet tube as well
as the connection carbine to a water container (I use 5 litres containers from the property
market (distilled water). In addition you need for example a round cable canal and some
string and a 5 litre container itself.
5a 5b 5c
