Quick Install Guide
1
2
Attach the Antennas
S
crew the male antennas until
fully attached to SMA female
connectors of the Cellular
and/or GPS Modules.
C
onnect to the MAIN port, the
primary cellular antenna port to
transmit and receive signal, if
decide to use one LTE antenna.
D
o not over-torque the antenna
on the connector.
LAN -
Green: Connected to a Gigabit (1000Mbps) device.
Orange: Connected to a 10/100Mbps device
Blinking: Data being transmitted / received
LTE Signal Strength
–
Green: RSSI > -69dBm. Excellent
Green / Fast Flashing: -69 > RSSI > -81dBm. Good.
Red / Fast Flashing: -81 > RSSI > -99dBm. Fair.
Red / Slow Flashing: -99dBm > RSSI. Poor
Red: No Cellular signal. Cellular module still in service
Off: No Cellular module or module failure
Internet -
Green: IP traffic via WAN
Red: WAN IP request failed
Off: No WAN connection or in Bridge mode
Power -
Green: System ready. Red: Boot failure
WHAT’S IN THE BOX
1 x BEC MX-200e WWAN Failover Manager
1 x This Quick Install Guide
1 x CD containing the User Manual
1 x DIN Rail Mounting Kit
1 x Power Terminal Block 2-Pin 3.5mm
1 x Power Converter with 2-Pin Terminal Block
1 x DC Power Adapter, 12V 1.2A
(Optional Accessories)
3G/4G Antennas
Active GPS Antenna
Ethernet (RJ-45) Cable
SETTING UP THE ROUTER
DEVICE OVERVIEW & LEDS
Insert the SIM card
S
lide the SIM card (2FF)
with the mental contacts
(gold plate) facing down to
the SIM slot then push it
all the way in until you
hear the clicking sound.
Connect the Serial (RS-232)
U
se a RS-232 (DB-9)
male serial adapter to
connect
with
industrial
equipment
– including
PLC, SCADA, Sensor,
Meters, and Motor.
3
4
5
A
ccess to the MX-200e Web Graphic Interface (GUI) by entering
in the address bar of the web browser.
D
efault Login Information: Username / Password (
admin
/
admin).
T
he
Quick Start Wizard
provides key steps to connect the MX-200e
to the Internet.
Connect to the MX-200e
1.1
A
ttach
the
power
converter
with
2-pin
terminal
block
to
the
MX-200e and plug in the
supplied power adapter
Connect to Power Source
1.2 A
ttach the
power
terminal block (TB)
to the
MX-200e and connect the wire
leads of the power supply
cable to the TB plug.
T
he
red
wire (Power/VCC -
the left connector) should
connect to the positive
terminal.
The
black
wire to the ground
(GND - the right connector) of
the power supply. Input
voltage range is from 9-56V.
1
2
3
4
