48
11g and 11n devices in your network, then keep the default in
mixed mode
. From the
drop-down manual, you can select
802.11g
if you have only 11g card. If you have only 11b
card, then select
802.11b
. If you have only 11n card, then select
802.11n
.
ESSID:
The ESSID is the unique name of a wireless access point (AP) to be
distinguished from another. For security propose, change to
a unique ID name to the AP
which is already built-in to the router’s wireless interface. It is case sensitive and must not
excess 32 characters. Make sure your wireless clients have exactly the ESSID as the device,
in order to get connected to your network.
Note:
ESSID is case sensitive and must not excess 32 characters.
Hide ESSID:
It is function in which transmits its ESSID to the air so that when wireless
client searches for a network, router can then be discovered and recognized. Default setting
is
Disable.
Enable:
Select Enable
if you do not want broadcast your ESSID. When select
Enable, no one will be able to locate the Access Point (AP) of your router.
Disable:
When Disable is selected, you can allow anybody with a wireless client to
be able to locate the Access Point (AP) of your router.
Regulation Domain:
There are seven Regulation Domains for you to choose from,
including
North America (N.America)
,
Europe
,
France
, etc. The Channel ID will be
different based on this setting.
Channel ID:
Select the ID channel that you would like to use.
Channel
Wdith:
Select either
20 MHz
or
20/40 MHz
for the channel bandwidth. The
higher the bandwidth the better the performance will be.
Tx Power Level:
It is function that enhances the wireless transmitting signal strength.
User may adjust this power level from minimum 0 up to maximum 100.
Note:
The Power Level maybe different in each access network user premises environment
and choose the most suitable level for your network.
AP MAC Address:
It is a unique hardware address of the Access Point.
AP Firmware Version:
The Access Point firmware version.
WPS service:
Enable / disable
WPS State:
Current WPS state in AP. It is be used for WCN (Windows Connect Now).
Configured:
This AP is be configured via WPS. It is not allow to configure via WCN.
Unconfigured:
This AP is un-configured via WPS. It can be configure via WCN.
Wireless Distribution System (WDS)
Содержание 7300N
