V2021.01
examples of unfavorable clamp designs
examples of favorable clamping designs
clamp with
narrow and small
clamping surface
/ clamping via
narrow bars
non-round
clamping
asymmetrical
clamping slot and
/ or oblique clam-
ping screws
Page 3
Attention: TRICKSTUFF brakes
The TRICKSTUFF brakes Maxima and Direttissima
have only a one-sided support of the brake pump.
Furthermore, the brake body is not twist-proof toward
the milling clamp. Due to this, even minimal, but adverse
forces on the brake pump and / or on the brake lever
connection can cause local damage to the handlebars.
After each fall, as well as after each impact against the
brake pump, the brake lever or the brake lever connection,
the carbon handlebar must be checked immediately for
signs of irregularities! In case of doubt, the handlebar
should be replaced. Otherwise, the handlebar may
suddenly break.
Attention: Clamping area
The brake and shift levers may only be mounted in the
clamping area. The distance between the levers and the
edge of the clamping area must be at least 2mm. Please
refer to the illustration above.
INSTALLATION OF HANDLEBAR GRIPS
Handlebar grips may be fastened with a maximum of 2Nm.
INSTALLATION OF BARENDS
The mounting of barends is not permitted on the Flat Bar 2.0.
INSTRUCTION MANUAL
FLAT BAR 2.0
clamping area of the
brake and shift levers
clamping area of the
brake and shift levers
safety distance to the border of the
clamping area of at least 2mm
