Beast B10, Руководство пользователя

Страница: 12 / 28

Tips & Tricks
Shake Method to Loosen Stuck Ingredients
When blending tough foods, large ingredients, or with a
limited amount of liquid in the vessel, the contents of the
Blending Vessel may become stuck and require a manual
method of freeing up the contents in order to continue
blending.
1. Remove the Blade Assembly with Blending Vessel from
the Blender Base.
2. With the Blade Assembly and Blending Vessel in hand,
shake it up and down thoroughly.
3. Reattach to the Blender Base to finish blending.
How to Crush Frozen Fruit
Pulsing is a useful way to coarsely chop ingredients without
totally emulsifying them.
1. Pulse 5-7 times to chop up and soften ingredients, and
then use the full Blend Cycle
2. Make sure your blend has at least 1/3 liquid as this is the
optimal ratio for the best blending experience!
19 20
Troubleshooting
Please refer to LED Light Behavior in the “Using Your B10
Blender” section.
• If the LED light indicator displays:
No Visible Light
That Means:
Your blender unit is not powered on.
Try: Make sure that the Blender Base is plugged into a
functioning standard 120-volt AC electrical outlet. Then
power ON the unit by pressing the Power Switch at the back
of the unit.
• If the LED light indicator displays:
Solid-Amber Color Light
That Means: Your blender unit is powered on, but the Blade
Assembly and/or Blending Vessel is not properly connected.
Try: Confirm that the Blade Assembly is firmly threaded
onto the Blending Vessel. Then confirm that the Blade
Assembly and Blending Vessel are twisted onto the base
until it clicks into place and the LED indicator displays a
Solid-White color light.
Then:
1. If the light is still flashing amber, press the orange switch
button on the back of the base to turn off the blender and
unplug for 24 hours to reset the unit.
2. While the unit is unplugged from the outlet, use a damp
towel to wipe down the contact points on the base of the
unit and blade assembly. Reference below diagram for
contact points on blender base.
3. Finally, use a dry towel to wipe down the contact points to
ensure it is completely dry and ready to be connected.