Beast-Tek Instruments Transmuter V1.5, Руководство по сборке

Страница: 10 / 34

www.beast-tek.com Transmuter Build Guide
Page 10
IO Board – Step 9
Carefully slide the panel over the components and again finger tighten about 6 or 7 washers.
Flip the panel over and make sure the LEDs are pushed through the panel all the way. Make
sure everything is seated nicely then solder one pin of the thonkiconn jacks, LEDs. You may
need to push the push button switch back up so that its flush with the PCB – if it keeps falling
out you can use a piece of sticky tape or blu-tack etc to hold it in place. Once one pin of each
component is soldered to hold it in place, flip the panel over and finger tighten the remaining
nuts. Make sure everything is seated nicely and when you are happy, solder the remaining
joints then tighten the jack nuts with an appropriate tool.