BEARWARE 300791, Руководство пользователя

Страница: 10 / 32

10
English
4. Initial use
Remove the wireless sockets and the remote control from the packaging. Insert the
batteries into the battery compartment at the back of the remote control.
Now plug the first wireless socket in a properly installed earthed socket at your
home and wait till the LED starts flashing.
Note: If the LED does not start flashing, press the "ON-OFF" button on the wireless
socket for 3 seconds until the display starts flashing.
A channel can now be assigned to the wireless socket. To do this, press one of the
"ON" buttons on the channels 1-4 on the remote control. Then the LED of the wire -
less socket starts flashing at brief intervals and subsequently goes out. The wireless
socket has now been assigned to that channel, whose "ON" button you are using
on your remote control.
Repeat the procedure with the two other wireless sockets of the set. The devices
are then ready.
5. Switching the wireless sockets on and off
You can choose to control the wireless sockets of one channel or all the devices
together.
Press the "ON" button on the remote control of one of the channels 1-4 to acti -
vate the wireless sockets of the corresponding channel. The associated devices are
switched off by pressing the "OFF" button.
If the LED on a wireless socket is glowing continuously it means that it is switched
on. If the LED is continuously inactive, then the same applies to the socket.
To control all the wireless sockets at the same time, you can use the "ALL" buttons
on the remote control.