Beamz S1500 DMX, Инструкция по эксплуатации

Страница: 4 / 16

- 4 -
Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied holder and
fixing screws.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 1500W heating element will draw unnecessarily current.
Timer remote control
Connect the remote control to the connector on the back of the fogger.
After some warm-up time, the device is ready for use, the LED will light up on the remote. During use, it may happen that
the machine stops, in this case the LED will go out, indicating that the machine is warming up.
Timer function:
Press the yellow button and set the interval, duration and volume controls to the desired level.
Interval: time between the smoke moments (10-200 seconds)
Volume: amount of smoke (0-100%)
Duration: duration of the smoking time
Continuous function:
Press the red button and set the volume to the desired level. The machine will continueously produce an amount of
smoke. It may be that the machine in between have to warm up, during this period no smoke is produced. How many
times this is done depends on the amount of smoke.
Manual Mode:
Press the green button to produce 100% smoke immediately; this button overrides all previous settings.
DMX control
Connect the device directly to a DMX controller or a DMX loop with multiple DMX effects. The machine has a 3-pin XLR
connector for DMX connection.
Address Setup:
Use the DIP switch on the rear panel to set the start address. The base/start address is defined as a first channel, where
responsive to the device. Check if no overlapping channels are used!
Example addressing:
DMX address DIP on Value for DIP switch Diagram
10
DIP 4
DIP 2
8
2 (8+2 = 10)
24
DIP 5
DIP 4
16
8 (16+8 = 24)
233
DIP 8
DIP 7
DIP 6
DIP 4
DIP 1
128
64
32
8
1 (128+64+32+8+1
=233)
Note:
It is necessary always lock a DMX loop with a 120 Ohm terminator for correct data transmission.
CHANNEL VALUE FUNCTION
1
0 – 100% Smoke level