Beamz LED PAR36 DMX SPOT, Инструкция по эксплуатации, Страница: 6 / 8

- 4 -
resisto
r
IN OUT IN OUT IN OUT
120 Ω
Settings and operation
Press “Menu” to switch to the Menu.
DMX address setting.
When display shows “address” you can set the DMX address. Press
“ENTER” to set address.
Press “UP” or “Down” to adjust the value (001 – 512), press “ENTER” to
save the address setting.
Work mode setting.
When display shows G-x (x = mode number 0 - 4)
0 = DMX control
3 = Sound activation 2
1 = Auto mode 4 = Sound activation 3
2 = Sound activation 1
Press “UP” and “DOWN” button to adjust, press “ENTER” to save.
Slave setting
When display shows “SLAV” it’s in slave mode
Factory value setting
When display shows “REST” press “ENTER” to set the unit back into factory settings.
DMX Settings
Channel DMX Value Function
1 0 - 255 Dimmer
2 0 - 255 Red dimmer
3 0 - 255 Green dimmer
4 0 - 255 Blue dimmer
5 0 - 255 Flash
6
0 – 7 DMX mode CH1-5
8 - 255 Color Fade slow-fast + Dimmer CH1
7
0 – 7 DMX mode CH1-5
8 - 255 Color jump slow-fast + Dimmer CH1
8
0 - 29 DMX mode CH1-7
30 – 74 Auto mode
75 - 119 Sound active mode 1
120 – 164 Sound active mode 2
165 – 209 Sound active mode 3
210 – 255 Sound active mode 4
A DMX signal terminator is recommended to avoid a bad signal caused by other electrical devices. A DMX terminator is a
XLR connector with a 120Ω resistor between pin 2 and pin 3 of the XLR connector. Connect it to the last OUTPUT socket
of the final light.
See picture: