Beamz 154.077, Инструкция по эксплуатации

Страница: 3 / 22

3
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. DMX Connector
2. Power input (Adapter 5V DC /0.5A)
3. Universe DMX LED Indicator
4. Universe selection knob
5. Antenna
Noted: Standard this product works as a receiver, in case you use in combination
with the delivered XLR Male – XLR Male adapter, then you can use as transmitter
as well.
OPERATION
1. Connect the transmitter to the DMX controller and the receiver to the DMX input of the DMX controlled fixture.
2. Set each transmitter and receiver into operation by connecting its power unit to the power input and the mains plug to a
mains outlet (100-240 V~, 50/60 Hz). The status indicator shortly flashes red.
3. Set each transmitter and receiver to the same universe. For this purpose, shortly press the recessed button on the
devices with a thin object. The selected universe is colour indicated by the LED indicator.
4. As soon as the transmitter receives a DMX signal, the status indicator switches to red. Shortly afterward, the status
indicators of the receivers start flashing green to indicate that the DMX signal is being received. The DMX-controlled
units can now be controlled via 2.4Ghz.
DMX Universe Colour DMX Channels
1 Red 1 ~ 512
2 Green 1 ~ 512
3 Yellow 1 ~ 512
4 Blue 1 ~ 512
5 Magenta 1 ~ 512
6 Cyan 1 ~ 512
7 White 1 ~ 512