Beamz 151.266, Инструкция по эксплуатации

Страница: 9 / 12

9
SETTINGS AND OPERATION
Press “Menu” to switch to the Menu.
DMX address setting.
When display shows “A001” you can set the DMX address.
Press “UP” or “Down” to adjust the value (001 – 512), press “ENTER” to save the
address setting.
Work mode setting.
When display shows G-x (x = mode number 0 - 4)
0 = DMX control
3 = Sound activation 2
1 = Auto mode 4 = Sound activation 3
2 = Sound activation 1
Press “UP” and “DOWN” button to adjust, press “ENTER” to save.
Slave setting
When display shows “SLAV” it’s in slave mode
Factory value setting
When display shows “REST” press “ENTER” to set the unit back into factory settings.
DMX CHANNELS
Channel Function Value Description
1
000-036 Off CH2 independent dimming
037-072 Flash Speed Adjustable by CH2
073-108 Fade
109-146 Fast On and Slow Off
147-186 Fast Off and Slow On
187-216 Auto mode
217-255 Sound active mode
2
Dimmer 000-255 Dimmer CH1 is between 0-36
Speed 000-255 Speed CH1 is between 37-186
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.