Beamz 151.264, Инструкция по эксплуатации

Страница: 6 / 9

- 5 -
res
is
tor
IN OUT IN OUT IN OUT
120
Ω
Settings and operation
Press “Menu” to switch to the Menu.
DMX address setting.
When display shows “A001” you can set the DMX address.
Press
“UP” or “Down” to adjust the value (001 – 512), press “ENTER” to
save the address setting.
Work mode setting.
Axxx = DMX control
ATxx = Auto/Sound mode
Edxx = Auto mode
Slav = Slave mode
Load = Reset to factory defaults
Press “UP” and “DOWN” button to adjust, press “ENTER” to save.
Slave setting
When display shows “SLAv” it’s in slave mode
Factory value setting
When display shows “LoAd” press “ENTER” to set the unit back into factory settings.
DMX functions:
Channel DMX Value Function
1 0 - 255 Dimmer
2 0 - 255 White LED Group 1
3 0 - 255 White LED Group 2
4 0 - 255 White LED Group 3
5 0 - 255 Strobe (slow-fast)
6 0 - 255 Changing gradually (slow-fast)
7 0
– 255
Changing sharply (slow-fast)
8
0
– 29
DMX channels, channels from CH1 to CH7 are controlled by DMX
30- 74 Automatic mode
75 - 119 Sound control mode 1
120
– 164
Sound control mode 2
165
– 209
Sound control mode 3
210 - 255 Sound control mode 4
A DMX signal terminator is recommended to avoid a bad signal caused by other electrical devices. A DMX terminator is a
XLR connector with a 120
Ω resistor between pin 2 and pin 3 of the XLR connector. Connect it to the last OUTPUT socket
of the final light.
See picture: