Beamz 151.258, Инструкция по эксплуатации, Страница: 4 / 24

4
DISPLAY
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the
Mode -button, browse through the submenu by pressing Up or
Down .
Press the
Enter -button in order to select the desired menu.
You can change the selection by pressing
Up or Down . Confirm every selection
by pressing the Enter -button.
You can leave every mode by pressing the
Mode -button. The functions provided
are described later in this manual.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can
cause greater accumulation of dirt on the unit’s optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!