RST200 INSTALLATION & USER MANUAL
16
Installing RST200
This chapter explains how to install the RST200 and the Iridium fixed-mast antenna.
Warning:
Make sure the RST200 is switched off before you
install the cables. If you do not, the RST200 may be
damaged.
Note:
Before you install the RST200, determine if the unit is
preconfigured or needs customer configuration.
Mounting the RST200
The RST200 comes with two (2) standard right angle mounting brackets that allow
mounting for mobile and fixed positioning.
Note:
To ensure sturdy mount attachment:
1. Mount the RST200 on a clean, even surface.
2. Clean the mount surface of the RST200.
3. Use the correct type of screws.
4. If mounting on a wooden surface, m
ake sure the wood
is structurally sound.
5.
Leave enough room around the RST200 to allow
unhindered access to the rear panel.
6.
Do not install the unit in a permanently concealed
recess. You should be able to access and remove the
unit should future service be required.
