RST973 IN-VEHICLE INSTALLATION & USER MANUAL
25
Operation of the In-car kit
Now that you have completed all installation steps, follow these steps:
1. Ensure the Satellite terminal has power to the unit.
2. Ensure that the vehicle is located in an area where quality signal is available
3. Ensure the ignition is in ACC or ON position
4. The handset should now be showing registration on the network
5. Wait for the unit to register on the network
6. You are now ready to make and receive calls.
Checking Performance after Installation
To confirm that the phone is working properly, follow the instructions in this section.
Checking Phone Performance
1. Place a call. Place a call from the mobile and confirm proper operation.
2. Answer a call. Have someone place a call to the mobile, and confirm proper
operation.
Checking the Entertainment Mute Feature
If the entertainment mute feature has been connected, check it by following these
steps:
•
Enable the entertainment mute feature. Prepare the mobile to receive test calls
by enabling the entertainment feature. For instructions on enabling this feature,
refer to the User Guide.
•
Turn on the car radio and set the volume to an audible level.
•
Place a call. Place a call from the mobile and verify that the car radio volume is
muted.
•
Answer a call. Have someone place a call to the mobile. Verify that the car
radio volume is muted.
Important Notes:
The power to the terminal is dependent on the poser source chosen during
installation. If power is required at all times even when the vehicles turned off then
accessories input should be connected to constant 11-32V DC input.
Be aware of the possibilities of this however flattening the vehicle
battery.