IridiTRAK Installation & User Manual
Mounting the IridiTRAK Unit
The IridiTRAK enclosure has two (2) slotted mount holes on each side, of 4mm
diameter. Self tapping screws (eg. #6), or M3 or M4 machine screws/bolts can be
used to mount the IridiTRAK to a flat surface.
NOTE:
To ensure reliable sturdy fixing:
o
Mount the IridiTRAK on a clean, even surface.
o
Use the correct type of screws.
o
If mounting on brick or poured concrete surface, let the cement
completely dry before you mount the unit.
o
If mounting on a wooden surface, make sure the wood is
structurally sound.
o
Leave enough room around the unit to allow unhindered access
to the rear panel.
o
Do not install the unit in a permanently concealed recess. You
must be able to access and remove the unit should future
service/configuration be required.
Page 18 of 46
