1. Push the SIM holder button with a SIM
needle or paper clip.
2. Pull out the SIM holder.
3. Insert your SIM card into the SIM holder.
4. Slide the SIM holder back into the router.
5. Attach mobile antennas.
6. Connect the power adapter to the socket on
the front of the device. Then plug the other end
of the power adapter into a power outlet.
7. Connect to the device wirelessly
(SSID: BEAM_**** (unique to each device)).
Please enter username and passwor
d
Username
Password
admin
admin01
Login
1. To enter the router’s Web interface (WebUI), type
http://192.168.42.1
into the URL field of your
Internet browser.
2. Use login information shown in the image below when prompted for authentication.
Mobile Informatio
n
Mobile
Data connection stat
e
IMEI
IMSI
Sim card sta
te
Signal strengt
h
Connected
123456789012345
123456789012345
Ready
-79 dBm
3. After you login, you will be prompted to change your password for security reasons. The new
password must contain at least 8 characters, including at least one uppercase letter, one
lowercase letter and one digit. This step is mandatory and you will not be able to interact with the
router’s WebUI before you change the password.
4. When you change the router’s password, the
Configuration Wizard
will start. The
Configuration
Wizard
is a tool used to setup some of the router’s main operating parameters.
5. Go to the
Status > Network
page and pay attention to the
Signal Strength
indication (image
below). To maximize the cellular performance try adjusting the antennas or changing the location
of your device to achieve the best signal conditions.
Hardware installation
Login to device
Technical information
Radio specifications
RF technologies
GSM, GPRS, EDGE, UMTS/HSPA+, LTE, GNSS, WiFi
Max RF power
33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE, 20 dBm@WiFi
Bundled antennas specifications*
GSM/WCDMA/LTE antenna
690/900/1800/1900/2100/2700 MHz, 50 Ω, VSWR < 3.2, gain** 3.5
Bdi, omnidirectional, FAKRA D female connector
GNSS antenna
1575.42~1602 MHz, 2.2-5 VDC, VSWR < 1.5, active total gain** 2
d6B (typ.), RHCP polarization, FAKRA C female connector
*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used.
The user is responsible for the compliance with the legal regulations.
