INSTALLATION INSTRUCTIONS
STEP 1
The hot tub cover must be in the closed position prior to
mounting the lifter. Position the hot tub cover properly so it is
sitting squarely on the hot tub. Attach the pre-assembled
mounting bracket (see illustration 1) near the back, and close to
the top edge of the hot tub using the #10-1”woodscrews. We
recommend pre-drilling all holes with a 1/16” drill bit.
STEP 2
Ensure the cover hooks and foam grips are in place as shown in
illustration 2. Insert the longer end of the corner support arms
into the center pole so that it is situated parallel to the hot tub
cover with the cover hooks under the seam of the cover (see
illustrations 3 and 6).
STEP 3
Insert the slider pivot bracket into the mounting bracket and
position it so that the slider pivot bracket lines up with the back
of the hot tub and secure using #10-5/8” tapping screws (see
illustration 4).
STEP 4
Slide the hydraulic clamp over the pivot arm so that the flat side
of the clamp is to the outside pointing down. Slide the pivot arm
over the shorter end of the corner support arm. Align the pivot
bracket and feed the bolt pin through the bracket, through the
nylon washer, through the pivot arm and secure using the clevis
pin (see illustration 4).
PRE-ASSEMBLY
